 |
Zephyr Xport is the perfect companion to Zephyr
Xstream - the best selling ISDN audio codec in the world.
Using custom DSP modem technology developed by Telos,
coupled with exceptional aacPlus coding, Xport transmits 15kHz audio
to your studio's Zephyr Xstream using an ordinary POTS (analog) telephone line!
Want to hear how great Xport sounds? All
you need is:
-
A Zephyr Xstream ISDN Transceiver connected to an ISDN line,
and
-
Zephyr Xstream software v2.5.x or later. Press the System
button on your Xstream to check your software version. If you need to
update, follow the instructions in Section One below. If your Xstream is
already running the latest software, skip to Section Two.
|
|
Section 1: Update Your Zephyr Xstream
-
If you need to update to the latest Zephyr Xstream
software, visit
this page. The update page will open a new browser window;
follow the update instructions and close the window to return to
this page.
-
Should you need assistance, please contact
Telos by phone or e-mail.
-
To read the manual supplement that covers the new
functions included in version 2.5.x software, click
here.
|
|
Section 2: Hear The Remarkable Quality of Zephyr
Xport Transmitted to your Zephyr Xstream
-
Press <DIAL> on your Zephyr Xstream.
-
If needed, enter any required dialing prefix or
country code.
-
Enter the number for the Zephyr Xport Demonstration
Line:
-
In North America, dial "1 216 621
1826" using the keypad.
-
Outside North America, dial "216 621 1826
using the keypad.
-
Press <SEL>. Use the <V> key to move the
cursor to MODE.
-
Press <SEL>. Use the <V> key to move the
cursor to MODE and press <SEL>. Use the <^> or <V>
key to select "XPORT" for the mode. Press <SEL> to
confirm your selection.
-
Press <DIAL> to dial the Demonstration Line.
It will take a few seconds for modem negotation to occur.
After negotiation, you should see the "Lock 1 & 2" lights illuminate
over your Xstream's Receive meters.
-
Enjoy the demonstration! The complete series of
audio samples is a loop of about 10 minutes.
-
Don't forget to disconnect - Press <DROP>
<DROP> and confirm that the system has returned to Ready Ready
status.
|
|
|
