|
This
user-friendly desktop controller
is for use with the Telos ONE-x-Six,
1A2 and Direct
Interface Multiline Talk Show Systems, and controls line selection, conferencing, dialing,
and a number of special features. LEDs above each phone line selection
button indicate line status and show which lines are being fed to
active hybrids.
Six special function buttons
appear on the Switch Console:
-
Next
selects the line that has been ringing-in the longest. If no lines are
ringing in, it selects the line on hold the longest.
-
Busy All –
With the first press of this button, all lines that are neither in use nor
on hold are made busy. On the second press, busy lines are dropped. One or
more lines may be programmed as "hot lines" and will not be
affected by this feature.
-
Flash/New is primarily for use with PBXs or Centrex telephone
lines that require flashing to access features. The FLASH/NEW button can
also be used for dropping a line; that is, to hang up a line and get dial
tone back on the selected line without going through the usual OFF and LINE
button press sequence.
-
Record Mode enables the operator to conveniently start a tape recorder. To
ready the RECORD MODE, push the button once. The next time any LINE button
is pressed, an output on the back of the Direct
Interface, 1A2 Interface Module, or
ONE-x-Six will activate a recording device.
-
Record Stop –
When this button is pushed, a closure output on the back of the Direct Interface,
1A2
Interface Module or ONE-x-Six stops the
recording device. You may choose to assign another function to this button
and closure.
-
Delay/Dump User Button activates an external profanity delay via a closure output on
the back of the Direct Interface or 1A2 Interface Module or ONE-x-Six.
You may choose to assign another function to this button and closure.
|
• 
|
|